see what port ASDM is running on

You can port scan the firewall or

sh run | i http server enable

add a route on checkpoint CLI

route add -net 10.5.140.0/24 gw 192.168.0.1 (works for lgma need write mode on FW you are adding the route on open the correct policy for each fw before making the change)

Remove a route worked on PH
route del -net 192.168.80.0/20 gw 192.168.80.51


route add -net 192.168.80.0/20 dev eth15
gives this kind of route
192.168.80.0    0.0.0.0         255.255.240.0   U         0 0          0 eth15

Maybe this in newer versions
https://supportcenter.checkpoint.com/supportcenter/portal%3FeventSubmit_doGoviewsolutiondetails%3D%26solutionid%3Dsk39746

clish (enter clish if no already there)

set static-route 192.168.0.0/24 nexthop gateway address 10.0.0.1 priority 1 on

save config

exit

netstat -nr | grep 192.168.0.0

Run on both FWs

(works on REV fws)

Watch out for NAT's you may need to add to grp_No_NAT

There may be a static server NAT for the server.

Show routes
netstat -nr - show all routes

netstat -nr | grep 10.5.140

185.5.241.204

Use nslookup to find the IP addresses of the domain controllers

You can use Nslookup is a command-line tool that displays information you can use to diagnose Domain Name System (DNS) infrastructure.

1. Click Start, and then click Run.
2. In the Open box, type cmd.
3. Type nslookup, and then press ENTER.
4. Type set type=all, and then press ENTER.
5. Type _ldap._tcp.dc._msdcs.